After a new generator or a sealed generator has been run-in (the first 50 hours), the following maintenance work is required:
Clean or replace the air filter
Change engine oil
Replace or clean the filter element of the lubricating oil filter
Re-tighten all bolts and nuts
The new generator should try to avoid sudden increase of load or high-speed operation, and use the lubricating oil recommended by the manufacturer as much as possible. Do not mix different brands of lubricating oil. The lubricating oil contains various additives. Degraded performance, resulting in abnormal wear of moving parts.
When filling fuel into the fuel tank, there should be a filter at the fuel filling port, and it is better to put a filter cloth; the fuel should be left in the fuel tank for more than 24 hours to allow water and impurities to settle before use; usually, the drain plug of the daily fuel tank should be opened frequently The head drains water and sediment at the bottom.
Regular maintenance and planned maintenance are the key to prolonging the service life of the engine. The maintenance cycle and maintenance items should be adjusted appropriately according to the application, usage, and the properties of fuel and lubricating oil. If necessary, the maintenance should be carried out in advance. technicians to complete regular inspections and maintenance.
High-quality imported generator sets are often of great value, and should be used reasonably, pay attention to daily maintenance, prevent early wear and tear, prolong their service life, and keep them in a good standby state of rapid startup and investment at all times, so as to truly make the best use of everything.